Oxy-Fuel Burning (B-2)
This 5 day course provides an introduction to the cutting torch, petrogen torch and electric plasma arc cutting. Fitting, wearing and tying off of safety harnesses.
Subject matter covered in this course:
O.S.H.A. Sub part J
Set up and adjusting of regulators
Graduates must demonstrate proficiency in hooking up and adjusting cutting torches, hoses and regulators. Making clean drop cuts on steel plate, structural steel, and pipe. Hook up, light, adjust and apply the burning bar, Petrogen torch and Plasma Arc cutter. The fitting, wearing and tying off of safety harnesses.
